Treatment Of The Cutting Set; Sharpening The Cutting Plate; Changing The Clipper Blade; Lubricating The Clipper Blade - Aesculap Suhl FAV5 Gebrauchsanweisung

Aesculap Suhl GmbH
Clipper FAV5

4.3 Treatment of the cutting set

4.3.1 Sharpening the cutting plate

Note
For sharpening the cutting plate, please contact
Technical Service, see Chapter Technical Service.

4.3.2 Changing the clipper blade

Risk of injury caused by sharp
cutting plates!
Handle the clipper blade of
Clipper FAV5 with appropriate
WARNING
caution.
2
Fig. 4
Press ON/OFF switch 3 to switch off Clipper FAV5,
see Fig. 4.
Press clipper blade lock 2, see Fig. 4.
6
3
Fig. 5
Press forward clipper blade 12, see Fig. 5.
Detach clipper blade 12.
Clean open hinge 1 with a brush.
Install clipper blade 12 on hinge 1.
Plug in the power cord of Clipper FAV5.
Press ON/OFF switch 3.
Slightly push clipper blade 12 towards Clipper
FAV5.
Clipper blade 12 will click into position.
3
Check that clipper blade 12 is correctly seated on
Clipper FAV5.

4.3.3 Lubricating the clipper blade

Clean the upper and lower cutting plates with a
soft cloth or brush. Make certain that the gaps
between the cutting teeth are cleaned properly.
Slightly lubricate the upper and lower cutting plates
with special lubricant for clipper blades GT604.
12