Intended Use Of Clipper Fav5; Operating Principle Of Clipper Fav5; Preparation And Setup; Working With Clipper Fav5 - Aesculap Suhl FAV5 Gebrauchsanweisung

Aesculap Suhl GmbH
Clipper FAV5

2.3 Intended use of Clipper FAV5

Note
The device is intended exclusively for cutting animal
hair.
The Clipper FAV5 is used for clipping small animals.
The Clipper FAV5 is used with a clipper blade to be
selected according to the respective application.

2.4 Operating principle of Clipper FAV5

The Clipper FAV5 is switched on (off) by pushing the
ON/OFF switch up (down).
3.

Preparation and setup

Non-compliance with these rules will result in
complete exclusion of liability on the part of Aesculap.
When setting up and operating the product, always
observe:
– national regulations
operation,
– the national regulations on fire and explosion
protection,
– operating advisories according to IEC-/VDE
regulations.
Prior to connecting the Clipper to mains power,
ensure that the voltage specified on type plate 5
matches the mains voltage.
Fire and explosion hazard!
Do not operate the product in
explosion-hazard areas.
DANGER
4
for installation and
Malfunction of, or damage to the
product caused by improper setup!
Do not expose the product to
direct sunlight or moisture.
CAUTION
Do not cover the ventilation
slots of the product.
Ensure that the mains power
socket used for supplying the
product is freely accessible.
4.

Working with Clipper FAV5

4.1 System set-up

4.1.1 Accessories

Combinations of accessories that are not mentioned in
the present instructions for use may only be employed
if they are specifically intended for the respective
application, and if they do not compromise the
performance and safety characteristics of the
products.
Please contact your B. Braun/Aesculap Partner or
Aesculap Technical Service (address: see Chapter
Technical Service) with any inquiries in this
respect.