Beurer HT 80 Gebrauchsanweisung Seite 25

Step 2: Plugging the mains plug into the socket
Insert the mains plug of the hot air brush into a suitable socket.
>
Step 3: Preparing your hair
Dry your hair with a towel beforehand.
>
Comb your hair thoroughly.
>
Only use the hot air brush on pre-dried, slightly damp and well-
brushed hair.
Step 4: Blower and temperature settings
Slide the sliding switch [6] on the hot air brush to the required blower
and temperature setting (2, 1 or
Setting Blower and tempera-
ture settings
2 High blower setting, high
temperature
1 Gentle blower setting, me-
dium temperature
High, cold blower setting
Step 5: After use:
After use, slide the sliding switch [6] to position 0.
>
Place the hot air brush on a heat-resistant surface and allow to cool.
>
Then clean the hot air brush as described in chapter "7. Cleaning".
>
Store the hot air brush in a safe, cool and dry place. If you prefer, you
>
can hang up the hot air brush using the hanging eyelet [10].
).
Hair type/application
For thick hair
For fine hair
For finishing the hairstyle
25