Technical Data; Cleaning And Care - Renkforce Prometheus Bedienungsanleitung

a) Charging the internal rechargeable battery
• Turn the lid (1) counter clockwise to remove it.
• Connect the included cable's Micro-USB plug to the Micro-USB input (3).
• Connect the USB plug to a suitable USB power supply (e.g. USB mains adapter with
2000 mA output current).
• The charge indicator (5) remains lit during charging.
• The charge indicator goes out when the internal rechargeable battery is fully charged.
• Disconnect the cable from the product and the power supply once the internal battery has
been fully charged. The product is now ready for use.
For infrequent use, we recommend fully charging the internal rechargeable battery
once every 6 months to maintain maximum performance.
b) Charging mobile devices
• Connect your mobile device to the USB charging port (2).
• Press the on/off button (10) to turn on the product. The mobile device battery is now charging.
The lantern (4) is also activated. The internal rechargeable battery's charge status (7) is
shown for approx. 10 seconds.
The lantern may not be turned off entirely during charging. If you do not need the
lantern, push and hold the – button (9) to dim the lantern down fully.
To check internal rechargeable battery's charge status, press the on/off button.
• Monitor the charging process. Once the charging has been completed, disconnect the USB
cable from the product and the mobile device.
• Press the on/off switch to turn off the product.
c) LED lamp
• Press the on/off button (10) to activate the lantern (4). The internal rechargeable battery's
charge status (7) is shown for approx. 10 seconds. The power indicator (6) remains lit.
• Press the + button (8) to increase the brightness.
• Press the – button (9) to decrease the brightness.
• Press the S button (11) to use the lantern to send an SOS. Press the S button again to turn
off the SOS.
• Press the on/off button to turn off the lantern.
Automatic power-off after 5 minutes: Press the T button (12). The charge status
indicator (7) flashes three times. The lantern turns off automatically after 5 minutes.
d) Charge status indicator
1 LED lit: 0 – 24 % remaining battery capacity
2 LEDs lit: 25 – 74 % remaining battery capacity
3 LEDs lit: 75 – 100 % remaining battery capacity
e) Carabiner
The carabiner is intended for hanging the product only. Do not use the carabiner for
any other purpose.
• Attach the carabiner to the lid (1) to hang the product from suitable equipment.
• You may also attach the product to a suitable hook without using the carabiner. Make sure
the product cannot fall down.

Cleaning and care

• Disconnect the product from any connected devices before cleaning.
• Under no circumstances use aggressive cleanings agents, cleaning alcohol or other chemical
solutions since these can penetrate the housing or impair functionality.
• Never submerge the product in water.
• There are no components located inside the product you need to maintain. Never open/
dismantle the product.
• Clean the product with a dry, fibre-free cloth. You may use a cloth dampened with a little
lukewarm water to remain tougher stains. Do not apply too much pressure to the housing to
prevent scratching.
• You can easily remove dust using a long-haired, soft and clean brush.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste. At the end of its service life, dispose of the product in accordance
with applicable regulatory guidelines.
You thus fulfill your statutory obligations and contribute to the protection of the
environment.

Technical data

Input voltage/current ..................... 5 V/DC, 2000 mA
Output voltage/current .................. 5 V/DC, 500 mA
Rechargeable battery ................... Li-ion, 10400 mAh
Number of LEDs ........................... 42
Luminous flux ............................... 30 – 1000 lm
Operating time .............................. max. 100 h
Charging time ............................... 5 h
Protection type .............................. IP54
Cable length ................................. 95 cm
Operating conditions .................... -10 to +80 °C, 1 - 80 % RH
Storage conditions ........................ -10 to +80 °C, 1 - 85 % RH
Dimensions (Ø x H) ...................... 113 x 88 mm
Weight .......................................... 490 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represents the technical status at the time of printing.
Copyright 2016 by Conrad Electronic SE. *1493552_V1_1116_02_IPL_m_en