PE N L
PE N L
DA DA
Luminaire with DALI electronic control gear
PE N L DA DA
Luminaire with DALI electronic control gear
Other luminaires, no more than
50 DALI electronic control gear units
w Sensor / For in depth informationen see Sensor operating manual
2.1.3. Parallel connection of sensors
For applications that require more than one sensor, a
three sensors. When using more sensors, care must be taken to ensure that the DIP switches (E) on the individual
sensors are set correctly. Sensors with identical DIP switch settings on a controller result in the system mal-
functioning. Applications with several sensors are, for instance, the individual daylight-dependent regulation of
two luminaire groups with two light sensors or the expansion of the presence detectors' area of coverage by using
additional presence sensors.
D
T1: ON/OFF/DIM Gr.1
T2: ON/OFF/DIM Gr.2
T3: ON/OFF/DIM Gr.3
T4: ON/OFF/DIM Gr.4
Controller: LGC - ES03/L/D
Order no.: 171 292
The maximum 50 electronic control
gear units can be assigned to no
more than 4 groups thanks to DALI
addressing.
Y-distributor OMD2
Fig. 2
Addressing mode
controller may be connected to a maximum
T1: ON/OFF/DIM Gr.1
T2: ON/OFF/DIM Gr.2
T3: ON/OFF/DIM Gr.3
T4: ON/OFF/DIM Gr.4
29