Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
0---39
40---59
60---79
80---89
90---99
100---109
110---119
120---129
130---139
17
140---149
150---159
160---169
170---179
180---189
190---199
200---219
220---255
The following points have to be considered during the inspection:
All screws for installing the devices or parts of the device have to be tightly connected and must not be corroded.
There must not be any deformations on the housing, glass pane, fixations and installation spots.
The electric power supply cables must not show any damage, material fatigue or sediments. Further instructions
depending on the installation spot and usage have to be adhered to by a skilled installer and any safety problems
have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or solvents.
CAUTION: Disconnect from mains before starting maintenance operation!
Cleaning and Using Frequency of Product
Please make sure that the light is power off before dismantling or maintaining, it's very important to keep the light
clean. Frequent cleaning will ensure maximum brightness output, but also prolong the life time. It's suggested to use
the high quality, professional glass detergent and soft cloth to clean the light. It's not allowed to use alcohol or
chemical solvent. The inner part of the light should be cleaned by vacuum cleaner at least once a year.
When the light doesn't work, please check if the fuse is burnt out or not. If it is, the same fuse should be replaced,
find out the faulty and restart the light. But please note the repair must be handled by professional.
© Copyright LOTRONIC 2015
No Function
Lamp On
Lamp Off
All Motors Reset
Pan/Tilt Motors Reset
Color Motor Reset
Gobo Motor Reset
Shutter & Dimmer Motors Reset
Other Motors Reset
Enable Blackout While Pan/Tilt Movement
Disable Blackout While Pan/Tilt Movement
Enable Blackout While Color Change
Disable Blackout While Color Change
Enable Blackout While Gobo Change
Disable Blackout While Gobo Change
System Reset
No Function
SHOOTER-2R
FUNCTION[Active After 5S]
Page 13
Werbung
Inhaltsverzeichnis
