Team DAI 4 Gebrauchsanleitung Seite 9

Fax +32 2 359 95 50

SPRAY
 Produces a mist for removing stubborn creases.
 Spray can be used at any temperature setting and during either dry or steam pressing.
Press down the spray button to spray.
STEAMJET
The steam jet feature provides additional steam for removing stubborn creases.
CLEANING
After using the iron for a long period of time and regularly (at least once every month) you
can clean your iron by using the self-cleaning function as follows:
 Fill the water tank halfway and put the iron on its heel.
 Set the temperature dial to its highest position and let the iron heat up until the pilot lights
goes out.
 Unplug the iron, turn the steam button to the self-clean position
the left and to the right above a sink. When doing so, press the steam jet button several
times. Hot water and steam will come out of the soleplate. This way, dust particles can be
eliminated.
 When the water tank is empty, turn the steam button to
 Pour water in the water tank, let the iron heat again and pass the soleplate on an old but
clean cotton cloth. The water remaining in the soleplate will evaporate, which will
complete the cleaning process.
 To clean the plastic parts of the iron, use a humid cloth.
WHEN YOU HAVE FINISHED IRONING
 Turn temperature dial to "MIN" and unplug iron from electrical outlet.
 With soleplate facing away from you, turn iron upside down to empty water.
 Then store the hot iron on its heel rest so that any remaining moisture will evaporate.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
9
Assembly page 9/20
and shake the iron to
.
TEAM DAI 4 - 050419