Pump does not start or stops suddenly during operation.
Causes:
The floater does not work. The motor cut-
off switch has not triggered. Rotor is stuck.
The overheat protector has cut off the
pump due to overheating. No electricity.
Dirt particles (e.g. gravel) have deposited
in the suction opening.
1220365 BDA.indd 20
Remedy:
Check cables/plugs/fuses.
Attention: send the pump to customer
service under all circumstances!
Excess
liquid
+ 35 °C. The suction part is clogged. Clean.
Check the electricity source. Pull the mains
plug and clean the turbine. Make sure that
the maximum admissible temperature of
35 °C is not exceeded. Check the fuses and
the electric connections. Clean the suc-
tion opening. Check the electricity source.
20
temperature,
max.
24.11.14 16:20