Nstall Multi - Channel Pump Head On Pump Drive - Heidolph PD 5001 Betriebsanleitung

adapter had been procured as an option for an existing pump drive, install item as stipulated
below:
Plug screws (50) from hardware kit in holes provided.
-
Align multi-channel adapter coupling with counterpiece (51) on pump drive.
-
Fit multi-channel adapter in coupling, align screws (50) with threaded holes (52) and pull both
-
screws (50) tight with a screwdriver.
4.2. Install multi-channel pump head on pump drive (fig. 32)
Tooling required: long-reach screwdriver (from hardware kit).
To install pump
-
head on pump
drive, align follower
pin (54) with slot in
multi-channel
adapter (53, fig.
31).
Secure pump head
-
on pump drive with
4 ea. screws (55,
from hardware kit);
use special
screwdriver from
hardware kit.
We recommend to support the pump head for this action; use adjustable foot (56) for
-
leveling. Pull lock-nut (57) tight against the pump head's underside.
CAUTION: the multi-channel pump head's drive C 8 follower pin features a plastic sleeve
-
(58) over the follower pin (54). Check for proper seat of parts. The plastic sleeve (58) is used
for cushion between both parts of the coupling, limiting noise emission to a minimum. This
sleeve (58) needs to be inspected after every 500 hours of operation and replaced on
condition. Sleeve P/N: 23-09-01-01-88-0
SCREWS TO SECURE
PUMP DRIVE
ACCES FOR
SCREWDRIVER
ADJUSTABLE FOOT
CAUTION: absence of SLEEVE (58) will harm the pump head.
GUARD
ACCESS FOR
SCREWDRIVER
57
LOCKNUT
ADJUSTABLE
56
FOOT
PINS USED TO INSTALL
HOSE CASSETTE
55
56
ATTACHING HOLES
FOLLOWER PIN
GUARD
PINS USED TO
INSTALL HOSE
CASSETTE
57
57
LOCKNUT
51
55
SCREWS TO SECURE
PUMP DRIVE
ATTACHING HOLES
54
FOLLOWER PIN
fig. 32
58
PLASTIC SLEEVE
fig. 33
IEI