Safety; Battery Replacement; Safety Warning - Wavetek Meterman CT-238 Bedienungsanleitung

current flow is in the direction shown by the arrow on the probe.
True r.m.s. readings may be obtained by using an appropriate true r.m.s. reading
multimeter.

4. SAFETY

This instrument is designed to be safe under the following conditions:
- indoor use
- altitude up to 2000m
- temperature 0°C to +50°C
- maximum relative humidity 80% for temperatures up to 31°C decreasing
linearly to 40% relative humidity at 50°C.
Use of the probe on uninsulated conductors is limited to 300V r.m.s or d.c.
and frequencies below 1kHz.
Safety in its use is the responsibility of the operator who must be a suitably
qualified or authorised person.
Do not use the probe if any part of the probe including the lead and connector(s)
appear to be damaged or if a malfunction of the instrument is suspected.
When using the probe ensure that your fingers are behind the protective
barrier see Fig. 1.
Clean the case periodically by wiping it with a damp cloth and detergent. Do
not use abrasive cleaners or solvents. Do not immerse the probe in liquids.

5. BATTERY REPLACEMENT

SAFETY WARNING: Before removing the battery cover, make sure
that the probe is remote from any live electrical circuit.
The red LED will flash when the minimum operating voltage is approached.
Refer to Fig.1 and use the following procedure.
Unclamp the probe from the conductor, turn it off using the On - Off switch and
disconnect the output leads from external equipment. Loosen the captive screw
which secures the battery cover. Lift the cover through 30° and pull it clear of
the probe body as shown in Fig 1. The battery is then accessible. Replace the
battery and re-fit the battery cover and fasten the screw.Replacement with other
than the specified type of battery will invalidate the warranty. Fit only Type 9 V
PP3, Alkaline (MN 1604 ).
BATTERY COVER
BATTERIEFACHDECKEL
COUVERCLE, COMP.
PILE
ZERO ADJUST
NULLABGLEICH
AJUSTAGE DU
ZERO
LED
Fig. 1
JAWS
ZANGE
PINCE
ZERO
ADJUST
OFF ON
CT238
ON
AC/DC CURRENT PROBE
OUTPUT: 100mV/A
MAX CURRENT: 20A RMS
– 3 –
BATTERY COVER SCREW (CAPTIVE)
SCHRAUBE, BATTERIEFACH
VIS, COMPARTIMENT PILE
PROTECTIVE BARRIER
SCHUTZSPERRE
BOUCLIER DE
PROTECTION
ON/OFF SWITCH
EIN/AUS SCHALTER
BOUTON MARCHE/
ARRET