Inhaltsverzeichnis - Wavetek Meterman CT-238 Bedienungsanleitung

The CT238 Current Clamp is warranted against any defects of material or
workmanship within a period of one (1) year following the date of purchase of
the multimeter by the original purchaser or original user.
Any multimeter claimed to be defective during the warranty period should be
returned with proof of purchase to an authorized Wavetek Meterman Service
Center or to the local Wavetek Meterman dealer or distributor where your
multimeter was purchased. See maintenance section for details.
Any implied warranties arising out of the sale of a Wavetek Meterman
multimeter, including but not limited to implied warranties of merchantability
and fitness for a particular purpose, are limited in duration to the above stated
one (1) year period. Wavetek Meterman shall not be liable for loss of use of the
multimeter or other incidental or consequential damages, expenses, or
economical loss or for any claim or claims for such damage, expenses or
economical loss.
Some states do not allow limitations on how long implied warranties last or the
exclusion or limitation of incidental or consequential damages, so the above
limitations or exclusions may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.
PLEASE READ SECTION 2 - SPECIFICATION BEFORE OPERATING
THE INSTRUMENT
Exceeding the maximum limits of this instrument is DANGEROUS.
Exceeding these limits will expose you to physical injury or even death and will
almost certainly damage your instrument. Even low-level voltages and currents
are capable of causing serious injury or even death.
Please do not use this or any piece ot test equipment without proper training.
Individual functions and ranges have different overload limits. It is VERY
IMPORTANT that you make yourself aware of these overload limits. Check the
specifications of these overload limits.
International Electrical Symbols
Caution! Refer to this manual before using
the probe.
Probe is protected by Reinforced or Double
Insulation.
CONTENTS
Warranty Statement
1 INTRODUCTION
2 SPECIFICATIONS
2.1 Electrical Data
2.2 General Data
3 OPERATING INSTRUCTIONS
3.1 Switch On
3.2 Zero Adjustment
3.3 Current Measurement
4 SAFETY
5 BATTERY REPLACEMENT
6 FACTORY SERVICE
7 FREQUENCY RESPONSE
AND ACCURACY CURVES
WARRANTY
WARNINGS AND PRECAUTION
OPERATING INSTRUCTIONS
Page 1
Page 2
Page 3
Page 3
Page 3
Page 3
Page 3
Page 4
Page 4
Page 4
Page 6
- 1 -