Installation Commissioning; Installation Options - STIEBEL ELTRON FES KOMFORT Bedienung Und Installation

INSTALLATION
COmmISSIONING
5. Commissioning
After the control unit has been connected allocate it a "terminal
address". The preset standard is 1.
»
Press MENU.
»
Go to menu item SETTINGS / COMMISSIONING / PROGRAMMING
UNIT / TERMINAL ADDRESS.
»
Select value 02 so the main appliance can capture the actual
values calculated by the programming unit.
»
Confirm with OK.
Allocate a heating circuit to the control unit.
»
Enter the 4 digit number code under CONTRACTOR / ENTER
CODE.
»
Select the desired heating circuit under SET TINGS /
COMMISSIONING / PROGRAMMING UNIT / HC ROOM T DETECTOR.
HC1 and HC2 are NOT available. Confirm with OK.
»
Press and hold the reset button on the ventilation unit for five
seconds. Alternatively, you can interrupt the power supply to the
ventilation unit for five seconds via the fuse/MCB.
See the operating and installation instructions for
the ventilation unit for information on operation and
settings.
FES Comfort | TCR Comfort
6.

Installation options

If you are not using a flush box you will have to drill four holes
(Ø 5 mm) for securing the wall mounted enclosure. You can find
the dimensions in the drilling template on the back page of this
document.
When routing the CAN-BUS lead, be careful not to damage the
cable when drilling the fixing holes.
In the area around the power supply cable entry (behind the wall
mounted enclosure) a reservoir needs to be made to support 20
to 30 cm of data cable.
7. Warranty and environment
In this respect, observe the operating and installation instructions
for the main appliance.
| 7