Herunterladen Inhalt Inhalt Diese Seite drucken

Ausbauhinweise; Disassembly Instructions - Grundig GV 464 HiFi Serviceanleitung

Inhaltsverzeichnis

Werbung

GV464...

1. Ausbauhinweise

1.1 Frontblende
– Rasthaken
(Fig. 1) lösen, Frontblende abnehmen und gege-
E
benenfalls Steckverbindung lösen.
Hinweis zum Zusammenbau: Beim Aufstecken der Frontblende
von vorne auf das Gerät ist die Cassettenklappe so nach innen zu
drücken, daß der Hebel in die Führung (siehe Basis-Service-Manual
S. 1-61 Fig. 4) der Cassettenklappe eintaucht.
1.2 Frontklappe
– 4 Scharnierstifte in die angegebene Pfeilrichtung schieben (Fig. 2).
– Frontklappe halb öffnen und abnehmen.
– 3 Schrauben
F
und 2 Schrauben
– Bedienfeld aus der Frontklappe nehmen.
1.3 Bedieneinheit I ausbauen
– Rastnasen
H
lösen (Fig. 4) und Bedieneinheit I abnehmen.
– Gegebenenfalls Steckverbindung lösen.
1.4 Bedieneinheit II ausbauen
– Rastnase
lösen (Fig. 4) und Bedieneinheit II abnehmen.
I
– Gegebenenfalls Steckverbindungen lösen.
1.5 Bedieneinheit III ausbauen
– 2 Schrauben
(Fig. 5) herausdrehen und Bedieneinheit III aus der
J
Frontklappe nehmen.
E
E
B
D
Fig. 2
GRUNDIG Servicetechnik
G
herausdrehen (Fig. 3).
E
E
Fig. 1
C
B

1. Disassembly Instructions

1.1 Front Panel
– Release the locking catches
E
unplug the connector if necessary.
Note: When attaching the front panel from the front to the video
recorder press the cassette lid inwards so that the lever engages
with the guide (see main Service Manual p. 1-61 Fig. 4) of the
cassette lid.
1.2 Front Flap
– Push the 4 hinge pins in the direction of the arrows (Fig. 2).
– Open the front flap halfway and remove it.
– Undo 3 screws
F
and 2 screws
– Remove the keyboard unit from the front flap.
1.3 Removing the Keyboard Control Unit I
– Release the locks
H
(Fig. 4) and withdraw the Keyboard Control Unit I.
– Unplug the connector if necessary.
1.4 Removing the Keyboard Control Unit II
– Release the locks
H
(Fig. 4) and withdraw the Keyboard Control Unit II.
– Unplug the connectors if necessary.
1.5 Removing the Keyboard Control Unit III
– Undo 2 screw
(Fig. 5) and remove the Keyboard Control Unit III
J
from the front flap.
G
Fig. 3
I
H
Fig. 4
J
Fig. 5
Servicehinweise / Service Instructions
(Fig. 1), remove the front panel and
G
(Fig. 3).
F
G
H
5

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis