Before First Time Use - Ideen Welt RFC-319 Bedienungsanleitung

Size - A6

BeFoRe FIRst tIme use

Remove the product and accessories carefully from the original
packaging. Inspect the delivery contents for completeness and
damages. Should the delivery contents be incomplete or damaged,
contact your sales outlet immediately.
The hair and beard clipper can be used as a battery-operated or
mains-operated (via the power supply unit) device. Before first use the
battery of the product has to be charged for 12 hours.
Charging the battery and battery operation
1. Connect the power supply cable to the port of
the charging dock (fig. 1) and then insert the
plug into a suitable power point.
2. Place the product on the charging dock. Make
sure that the on/off switch is pressed down.
note
You can also charge the product directly via
the power supply unit (Fig. 2).
3. The power indicator shows red to indicate that
the battery is being charged. No matter it is
directly charged with the power supply unit or
through the charging dock.
4. If the battery is fully charged the hair and beard
clipper can be used in battery mode for max. 45
minutes.
note
• The power indicator does not provide any information about the
charging status of the battery. If the output of the product drops
please charge the battery.
• To protect the life-span of the battery, do not charge the battery for
longer than 8 hours.
RFC-319_A6_140124_rev.indb 19
Fig. 1
Fig. 2
19
24/1/14 5:44 PM