Changing The Remote Control Battery - Grundig M 1100 Handbuch

CONNECTION AND PREPARATION
Connecting the power cord
Notes:
Check that the mains voltage on the type
7
plate (on the bottom of the hi-fi system)
corresponds to your local mains supply. If
this is not the case, contact your specialist
dealer.
All the other devices/loudspeakers must be
7
connected before you connect the power
cord.
1
Insert the power cord into the
on the hi-fi system.
2 Plug the power cord into the wall socket.
Caution:
The hi-fi system is connected to the mains
7
with the power cord. Pull out the power
plug if you want to completely disconnect
the hi-fi system from the mains.
Make sure the power plug is easily acces-
7
sible during operation and not hindered by
other objects.
Activating the battery in the
remote control
1
Changing the remote control
battery
1
2
3
»AC ~ « socket
4
5
Pull off the film from the battery.
Undo the battery compartment screws
Pull out the battery compartment
Insert the battery (3 V, lithium, type CR 2025)
making sure that the positive terminal (+) is
facing upwards.
Push in the battery compartment.
Tighten the battery compartment screws.
Notes:
Do not expose the batteries to extreme
7
heat, caused for example by direct sunlight,
heaters or fire.
Remove the batteries when they are flat
7
or when you know that the hi-fi system will
not be used for a long period of time. The
manufacturer accepts no liability for dam-
age caused by leaking batteries.
Environmental note:
Batteries, including those which do not con-
7
tain heavy metal, should not be disposed
of with household waste. Always dispose
of used batteries in accordance with local
environmental regulations.
---------------------------------------
25
ENGLISH