Herunterladen Inhalt Inhalt Diese Seite drucken

Assistance By The Electric Motor; Operating Principle Of Assistance; Distance - Derby cycle Pedelec Groove Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

6 Assistance by the electric motor

6.1

Operating principle of assistance

If you switch on the assistance and start pedalling, the
motor starts up once the cranks have completed roughly
two complete revolutions.
The amount of propulsion provided by the motor depends
on which level of assistance you have selected.
Motor output
(watts)
250
150
70
The motor can operate with three diferent power output
levels.
The motor delivers a continuous output of 70 watts
at the lowest level ECO, 150 watts at the medium
level SPORT, and 250 watts at the highest level
POWER.
When the switch is in the POWER position, the
motor assists you with the highest output and
therefore also uses the most energy. If you select
the SPORT assist level, the motor output is slightly
lower. If you select ECO, you will receive the lowest
level of assistance but will be able to use the maxi-
mum range of the battery.
The motor provides assistance until the Pedelec
reaches a speed of 25 km/h. It then switches of.
6.2
The distance you can travel using the power assist with
the battery ully charged depends on several factors:
Speed (km/h)
25

Distance

Ambient temperature
If it is colder, you will travel a shorter distance
with the same battery charge.
To maximise the distance you can travel, keep the
battery in a heated room so that it is at room tem-
perature when you it it on your Pedelec.
As the battery discharges when the motor is in use,
it generates enough heat to not lose too much of its
power at low ambient temperatures.
Level of assistance selected
If you wish to ride a long distance assisted by the
motor, select a low level of assistance (ECO).
Riding approach
You can ride assisted almost entirely by the motor
by turning the pedals very gently. However, this
uses more battery power. You can save power by
putting in more efort when turning the pedals.
Technical condition of your Pedelec
Make sure that the tyre pressure is correct. If you
ride your bike with too little air in the tyres, this
can signiicantly increase the rolling resistance.
This applies to smooth surfaces in particular, e. g.
tarmac. If the ground is uneven, as on a country
path or gravel track, rather low tyre pressure can
lead to less rolling resistance. This also increases
the risk of a puncture. Please consult your special-
ist dealer about this.
The distance you can travel also decreases if the
brakes are rubbing.
Topography
The motor uses more power when riding in hilly
rather than lat terrain.
11 11

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis