ATI FLEX-M Bedienungsanleitung Seite 10

1- GENERAL INFORMATION AND FEATURES
1.1 GENERAL WARNINGS
The operating and maintenance is an integral and
essential equipment and should be delivered to the
user. It should be stored carefully and consulted
carefully, as it contains important information on the
safety of operators, for the operation and for proper
maintenance. In case
information in the manual, contact the manufacturer.
The appliance must only be used for which it was
intended. Any other use is considered improper and
therefore dangerous.
And 'it is excluding any non-contractual liability of
the manufacturer for damages caused by errors in
the use and installation of the appliance, or failure to
comply with the instructions
manufacturer.
IMPORTANT
The manufacturer reserves the right to modify
the product and its technical documentation
without incurring any liability to third parties and
assumes no responsibility for any errors or
imprecision in the content of this booklet. The
present drafting of the manual for the use and
maintenance describes the characteristics about
the appliance of the series the date on which this
publication is fired for printing.
1.2 MANUFACTURER
The manufacturer is available to technical problems
or for ordering spare parts.
For any communication
recommend to always
information:
 serial number (serial detectable label)
 period of manufacture (detectable label serial)
 date of purchase (receipt or invoice copy)
 Detailed information about problems found
 product type
IMPORTANT
To replace some components we recommend the
use of original spare parts; the manufacturer
declines all responsibility for any deterioration of
the device performance for damages caused to it
due to the use of spare parts not original.
1.3 FOR IDENTIFICATION DATA
The label contains the serial number for identifying
the device serial number and the manufacturing time
needed to apply for spare parts or to report technical
problems to the manufacturer.
of doubt or for more
provided by
device purchased,
provide the following
1.4 INTENDED USE
The FLEX models, MINIJET, UNI-1 are all equipped
with a shower head and a foot lava.
temp
the
button.
tap
manual
1
mixer
temp
button.
we
tap
manual
The MUL-2 MUL-3 models and MUL-4 are designed
to simultaneously have more points of use in a
single device. Depending on the model provide
respectively 2, 3 or 4 shower heads and 1 or 2
washes feet.
Finally, the LAV model has been especially designed
for public utilities and is equipped with 2 sampling
points.
temp button.
tap
manual
temp button.
tap
manual
All items in the line are built in AISI 316L stainless
steel, which provides excellent corrosion resistance.
1 1
1 1
1 1
1 1
1 1
2 3 4
2 3
1 1 2
1 1
1 1
1
1
1
1
4
2
2 2