Safety Instructions; General Guidelines; Technical Specifications; User Manual - Velleman VTLLAMP1W Bedienungsanleitung

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken
to a specialized company for recycling. This device should be returned to your distributor or to a local
recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer. Damage caused by
disregard of certain guidelines in this manual is not covered by the warranty and the dealer will not accept
responsibility for any ensuing defects or problems.

2. Safety Instructions

Keep the device away from children and unauthorised users.
Indoor use only.
Keep this device away from rain, moisture, splashing and dripping liquids.
Never leave the magnifying lens unattended where direct sunlight may pass through
it: this creates a fire hazard.

3. General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
• Protect this device from shocks and abuse. Avoid brute force when operating the device.
• Protect the device against extreme heat, dust and moisture.
• Familiarise yourself with the functions of the device before actually using it.
• All modifications of the device are forbidden for safety reasons. Do not replace a damaged power cord yourself
but refer to an authorized dealer.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void the warranty.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• There are no user-serviceable parts.
4. Installation/operation
• Open the table clamp by twisting the T-handle counter clockwise.
• Slide the clamp over a suitable and solid horizontal surface capable of carrying it, T-handle at the bottom.
• Twist the T-handle clockwise until the clamp is firmly secured to the surface.
• Slide the stem of the lamp into the hole on top of the clamp.
• Plug the power cable into a suitable mains outlet.
• Switch on the lamp with the On/Off button on top of the lamp.
• The magnifying lens is protected by a hard cover. Fold it upwards to use the lens. Do not force. Always close it
when not in use to avoid fire hazard (sunlight).
• Optional (not incl.):
• stand with wheels: VTLAMPST
• table stand: VTLAMPST1

5. Technical specifications

colour
number of LEDs
dimensions
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of
damage or injury resulted from (incorrect) use of this device. For more info concerning this product,
please visit our website www.velleman.eu. The information in this manual is subject to change without
prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
06.07.2010
VTLLAMP1W

User manual

white
64
arm length 86 cm
glass Ø 145mm
dioptre
ratings
cable length
weight
2
Rev. 01
5x
230Vac / 6W
1.5m
2950g
©Velleman nv