Cameo AURO MATRIX 500 Bedienungsanleitung Seite 19

Settings
Display Rev =
Display =
DMX Fail =
DimmerCurve =
Pan Rev =
Tilt Rev =
Pan Angle =
Feedback =
Fan Set =
Mov Blackout =
Test =
Reset =
NETWORK SETTINGS (Network Setting)
Pressing the MODE button will take you to the selection menu for system settings. Using the arrow buttons, select the menu item "Network Setting"
(dark background) and confirm by pressing ENTER. You will then be taken to the sub-menu to set the following sub-menu items (select the sub-
menu items with +, -, set with ENTER, +, -, ENTER):
System Settings
DMX Address 001
Mode DMX 111CH
Settings
Network Setting
System Info
Flip Display ON
OFF
Display lighting ON
OFF
Operation status with DMX Hold
signal interruption
Auto
Blackout
Dimmer Curve Linear
Exp
Log
S-Curve
Pan Reverse ON
OFF
Tilt Reverse ON
OFF
Pan Angle 630
540
position correction ON
OFF
fan control Regular
Silent
Automatic blackout during ON
head movement
OFF
Function test ON
OFF
Reset Pan&Tilt
= Rotation of the display by 180° (overhead installation)
= no rotation of the display
= permanently on
= deactivation after approx. 20 seconds of inactivity
= last command is held
= activates the AUTO mode
= activates Blackout
= The light intensity increases linearly with the DMX value.
= Adjustment of the light intensity is finer in the lower DMX value
range and coarser in the upper DMX value range.
= Adjustment of the light intensity is coarser in the lower DMX value
range and finer in the upper DMX value range.
= Adjustment of the light intensity is finer in the lower and upper DMX
value ranges and coarser in the middle DMX value range.
= Reversal of the Pan direction
= no reversal of the Pan direction
= Reversal of the Tilt direction
= no reversal of the Tilt direction
= Pan angle 630°
= Pan angle 540°
= activates automatic position correction
= deactivates automatic position correction
= maximum brightness at normal fan function
= if necessary, reduced brightness at very silent fan function
= Blackout during head movement
= no blackout during head movement
= step-by-step function test of LEDs and motors (Pan, Tilt,)
= stops the function test
= Resetting of the Pan & Tilt motors
19