Sanitary-Grade Acrylic; Cleaning; Damage; Controls - Duravit Combi-System P Bedienungsanleitung

> Ensure that the room is well-ventilated during the disinfection process.
> Fill the tub with water.
> Add the chlorine bleach to the water in accordance with the manufacturer's in-
structions.
> Switch on the air nozzles for 20 seconds, and then the jet nozzles for 5 minutes.
> Allow the water in the tub to settle for 5 minutes.
> Switch on the air nozzles again for 20 seconds, and then the jet nozzles for 5 min-
utes.
> Drain the water and rinse the tub.
> Fill the tub with water again.
> Switch on the air nozzles for 20 seconds, and then the jet nozzles for 5 minutes.
> Drain the water.
> Repeat the process as necessary.

6.2 Sanitary-grade acrylic

Cleaning

> Clean acrylic with a soft, damp cloth.
> Use the Duravit Maintenance Set for Acrylic Surfaces for the occasional thorough
cleaning and for removing stubborn spots.
> Remove extensive soiling with warm water and a liquid detergent, dish washer
liquid or soap suds.

Damage

> Remove scratches and other surface damage with the Duravit Acrylic Surface
Maintenance and Repair Set (Art. No. 790302 00 0 00 0000).

6.3 Controls

> Clean the controls with a soft, damp cloth.

6.4 Drain and overflow fittings

> Clean the drain and overflow fittings with a soft, damp cloth.
25