Connections; Software Update; Functions; Dmx Bypass - MBNLED DMX RDM SPLITTER 4 Bedienungsanleitung

MBNLED DMX RDM SPLITTER 4

Connections

 Power: 100-240V AC 50-60Hz
 DMX in: 5pin XLR
 DMX out: 4 x 5pin XLR
 USB: PC connection, A-B USB cable

Software Update

The firmware of the device can be updated. The update possible via USB port but
also via DMX input. You can ask your distributor for necessary PC software and for
more information.

FUNCTIONS

After connecting the power cable the device ready ready to operate.
The GREEN LED of the INPUT button will be lit if device is powered.
The RED LED of the INPUT button will be lit if device receive DMX signal vie its DMX
INPUT port.
The output's have three operating modes:
DMX BYPASS (red LED)
-
DMX RENEW (no LED)
-
DMX/RDM (green LED)
-
The operating modes can be changed by pushing the buttons 1-4. All output settings
can be changed independently.

DMX BYPASS

Press 1 of the 4 output buttons until its RED LED is lit. Now the device is in DMX-
BYPASS mode.
www.mbnled.com 10 info@mbnled.com