Ryobi CRH1801 Betriebsanleitung Seite 5

GB
FR DE ES
OPERATION
WARNING
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
APPLICATIONS
You may use this product for the purposes listed below:
Drilling in all types of wood products (lumber,
plywood, panelling, composition board, and hard
board)
Drilling in ceramics, plastics, fiberglass, and laminates
Drilling in metals
Hammer Drilling in concrete
This product will accept Ryobi One+ 18 V lithium-ion
battery packs and Ryobi One+ 18 V nickel-cadmium
battery packs.
WARNING
Always remove battery pack from your drill
when you are assembling parts, making adjust-
ments, assembling or removing bits, cleaning,
or when not in use. Removing battery pack will
prevent accidental starting that could cause
serious personal injury.
BATTERY PROTECTION FEATURES
Ryobi 18 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life. Under some operating conditions, these
built-in features may cause the battery and the tool it is
powering to act differently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to
stop running. To reset the battery and tool, release the
trigger and resume normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
If releasing the trigger does not reset the battery and
tool, the battery pack is depleted. If depleted, the battery
pack will begin charging when placed on the lithium-ion
charger.
TO INSTALL BATTERY PACK
See Figure 2.
Follow these steps to install the battery pack:
Place the rotation selector in the centre lock position.
IT NL PT DK SE FI NO RU PL CZ
English
Insert the battery pack into the product as shown.
Make sure the latches on each side of the battery
pack snap in place and that battery pack is secured in
the product before beginning operation.
TO REMOVE BATTERY PACK
Follow these steps to remove the battery pack:
Depress the latches on each side of the battery pack.
Remove the battery pack from the drill.
WARNING
Batter y products are always in operating
condition. Therefore, the switch should always be
locked when not in use or carrying at your side.
ADJUSTING THE AUXILIARY HANDLE
See Figure 3.
Follow these steps to adjust the auxiliary handle:
Loosen the auxiliary handle by turning the knob
counterclockwise (12).
Rotate the auxiliary handle to the desired location.
Tighten the auxiliary handle securely by turning the
knob clockwise (11).
ADJUSTING THE DEPTH GAUGE ROD
See Figure 4.
Follow these steps to adjust the depth gauge rod:
Lock the trigger switch by placing the rotation selector
in the center position.
Loosen the auxiliary handle by turning the knob
counterclockwise (12).
Adjust the depth gauge rod so that the drill bit extends
beyond the end of the rod to the required drilling
depth.
Tighten the auxiliary handle by turning the knob
clockwise (11).
SWITCH
See Figure 5.
To turn the drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
SWITCH LOCK
See Figure 5.
The switch trigger can be locked in the OFF position.
This feature can be used to prevent the possibility of
accidental starting when not in use. To lock switch trigger,
place the rotation selector (Forward / Reverse Selector)
in center position.
Note: When selector is in center position, switch trigger
is locked.
2
HU RO LV LT EE HR SI SK GR TR