Brother KIT I Installationsanleitung Seite 8

i
Type in the internal machine identification
number (No.) written down in step
then click "Next".
If an error message appears
Check that symbols or characters other than
numbers have not been entered. To close the
message, click "OK".
j
Carefully verify that the information has been
entered correctly and then click "Certify".
Memo
• To change the entered information, click "Back".
If an error message appears
Check below list for possible error(s). To close
the message, click "OK".
• Verify that the CD key and internal machine
identification number (No.) have been entered
correctly, and then repeat the procedure from step
c
.
• The CD Key is valid for use with only one
designated internal machine identification number
(No.). Check that the CD key has been entered
correctly, and then repeat the procedure from step
c
.
• Check the Internet connection, and then click
"Certify" again.
6
k
Write down the 8-digit Certification Key that
a
, and appears.
Note
• After upgrading the sewing machine to KIT
Certification Key must be entered in the sewing
machine Settings screen.
l
Click "Finish".
The certification key has been successfully obtained.
Now proceed to installing the upgrade application for
I
KIT on the sewing machine.
Use USB media or a computer to install the upgrade
application.
USB media
If
follow.
If a computer
described on page 8.
is to be used, refer to the instructions that
is to be used, refer to the procedure
I
, the