Getting Started; Operating Instruction; Card And Usb; Photo Mode - Braun DigiFrame 1050 Gebrauchsanweisung

1 2

4. Getting Started

4.1. Put the digital photo frame with installed
bracket on a flat position steadily, then plug one
end of the AC adapter into a standard 110-240V AC
electrical outlet and the other end into the DC IN
slot on the left side of the frame.
4.2. Slowly Remove the protective film covering the
LCD.
4.3. Remove the plastic battery insulator from the
battery compartment and make sure the remote
control has a battery inside. Please refer to "Instal-
ling & Replacing Battery" if you need a new battery.
4.4. It will start up automatically when the power is
on.Press the power button on the backboard or
press the Power Button on the Remote Control to
Switch On/Off.

5. Operating Instruction

After turning on the unit, it will show the startup
picture, then slideshow will play automatically with
background music if there is Built-In Memory or
Memory card or USB device.
NOTE: Make sure there are supported picture and
music files in the card or USB device.
E N G L I S H

5.1 Card and USB

It supports SD /SDHC/MMC/MS and USB 2.0. After
inserting a card or USB device, slideshow will play
automatically, then press RETURN 2x to access to
Photo, Music, Video, File, Calendar and Setup.
Press OK to confirm.
Note:
1) Make sure there are supported Picture, Music
and Video files in the Card or USB device.
2) If there are supported picture and music files in
the Card or USB Device, slideshow will play
automatically with background music

5.2 Photo Mode

Press RETURN to choose Storage Device. Press
"OK" to enter into the main menu, choose Photo
and press OK to start slideshow , press Return to
enter into the 8-Pictures Mode, use
the picture and press OK to play. If the "Music" is
"On" in Photo setup, it will auto slideshow with
background Music and the music must be stored in
the same memory device! You can use VOL+/ VOL-
to turn up /down the volume.
/ to choose