August EP650C Bedienungsanleitung Seite 4

3. The status LED flashes blue to indicate a successful connection.
Note: Accessing Bluetooth settings on mobile phones varies for
each phone, to find the information for your phone, please refer to
its user manual.
- Multipoint
Multipoint allows you to connect your EP650C headphones to
two source devices at the same time. To create a multipoint
connection:
1. Hold the" " and" " buttons to put the EP650C into pairing
mode
2. Press " " to start multi-point pairing
3. Pair your headphones to your first source device
4. Switch your headphones off
5. Press and hold " " until your headphones reenter pairing
mode.
6. Pair your headphones to your second source device
7. Use the Bluetooth menu on your first source device to
reconnect to your headphones
To switch between source devices, pause the music on the
currently connected device then play music on the second device.
Switching devices can take up to 10 seconds.
Note: When receiving a call on either source device, the music
will automatically pause and resume once the call is finished.
- For computers
1. Enable the Bluetooth function on your computer.
2. Select "Devices and Printers" from the Control Panel and click
"Add a Device".
3. Select "EP650C" from the available devices, the system will
install the driver automatically.
Note: For Windows XP and Vista, a third-party Bluetooth driver
is needed (not included).
-5-
4. The status LED flashes blue to indicate a successful connection.
5. If the EP650C is not automatically set as your output device, select
"Sound" from the control panel then highlight the EP650C and
select "Set Default".
Note: When switched on, the EP650C will automatically reconnect to
the last paired Bluetooth device if it is in range.
- NFC
1. Enable Bluetooth and NFC functions on your source device.
2. Switch on the EP650C and enter pairing mode.
3. Touch the NFC area of your source device against the NFC area
on the left side of the EP650C. They will autocratically pair with
each other.
4. Confirm Bluetooth pairing if prompted. "EP650C" will now be
listed in your source device's Bluetooth device list.
5. To disconnect your device, touch the NFC area of your device
against the NFC area on the left side of the EP650C. Touch again
to reconnect.
5.3 Remote Control
The EP650C is able to control the music playing on either a
mobile phone or a computer with a Bluetooth connection.
Press " " to pause or resume playing music.
Press " " or " " to increase or decrease the volume.
Press " " or " " to select the previous or next track.
Note: Music playing control is only compatible with devices
that support A2DP, please refer to your devices user manual
for its A2DP compatibility.
-6-