Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Reset the watch
You can reset the watch as below:
While the watch is running step by step, pull out the middle crown while the second hand just stop at 12 o'clock so that the second hand stops at 12 o'clock
position.
Turn the crown to set Hour and Minute hands to 12 o'clock. Now all hands are set to 12:00:00.
Do not push-in the crown after all hands stop at 12:00:00, holding S2 for 15 seconds and then,
Push-in the crown. You watch does not run after the crown is pushed-in.
Place your watch near a window to get signal. The watch will start to update its first signal. It will continue updating signal for the coming 24 hours if the first signal
reception is not successful. After receiving a valid time signal, and the hands move on to the correct time.
Watch Stop at 12 o'clock and no talking function
When battery is low, the watch hands will stop and talking function is terminated. It is time that you need to change a new battery according to the "Battery
Change" procedures.
Watch Not Receiving Time Signal
Reason for not being able to receive the Time Signal includes:
-Being outside of the signal area
-Being in a build up area
-Metal objects blocking the radio signal
-Interfere by computer monitor or TV
Ensure that the watch is left by a window, as this gives the best reception, you may have to try different windows in the house to see which is best. You can test
this using reception status test described earlier. Please note that reception is always better at night.If your watch is unable to make contact with the radio signal,
it will continue to function in the same way as a standard watch. The time will then be corrected the next time your watch receives the time signal.
Battery Lifetime and Replacement
Request per Day
Battery Change
When battery is confirmed to be low, the watch hands runs 1 step every 2 seconds. There is no voice announcement anymore. It is time to change a new
battery.This watch uses a CR2025 type battery; trained jewellers or watch specialists should fit new batteries to avoid any damage to the watch.Open the watch at
the back. Carefully remove the bottom, make sure you are not losing the waterproof seal.Pick up the battery spring carefully.Take out the battery and insert a new
one (watch the polarity!"+"up).
Now push the battery spring down.Before you put the case-back on again, make sure the waterproof seal is correctly in place.
After battery replacement
2.
After battery replacement, the second hand starts to run when the crown is pushed-in
Wait until the second hand just stop at 12 o'clock and pull out the middle crown immediately so that the second hand stops at 12 o'clock position.
3.
Turn the crown to set Hour and Minute hands to 12 o'clock. Now all hands are set to 12:00:00.
4.
5.
Push-in the crown. You watch stop running after the crown is pushed in.
6.
Place your watch near a window to get signal. The watch will start to update its first signal. It will continue updating signal for the coming 24 hours if the first
signal reception is not successful. After receiving a valid time signal, and the hands move on to the correct time.
7.
After the watch is able to set the time automatically, you need to set Time Zone according to the following instructions:
Set USA Time Zone if you are a USA user. Go to "Time Zone Setting" for details.
If you are a Japan, UK or Germany user and provided that your watch is bought locally, you do not need to set time zone on your watch as your
watch has been set to your local time zone before leaving the factory.
Remark:
If the watch does not show you the right time after battery replacement, please reset your watch according to the "Reset the watch" as below.
REMARK:
1.
Anytime when the crown is pulling out, the watch hands stops while the internal clock is still running. After you push-in the crown, the watch will fast spin to
match the internal time automatically.
When the watch is fast spinning, don't pull out the crown. If the crown is pull out while the watch is fast spinning, the second hand will stop. After you push-in
2.
the crown, the watch will resume spinning to match the internal time.
Trend News Europe GmbH, Eichholzer Str. 3c, D-21436 Marschacht
Battery Life
0
1.5 Years
5
1
Year
10
8 Months
15
6 Months
20
5 Months
25
4 Months
6
RCTK34 / 05/17
Werbung
