Klingel WRCTK34 Bedienungsanleitung Seite 4

IM code: RCTKCR-Single775Khz-2
Your Analog Talking Watch is a Single-Band Radio Control watch.
It is able to pick up Germany DCF 77.5Khz signal.
It recalls the Atomic Clock (which measures each second of time as 9,192,631,770 vibrations of a cesium 133 atom in a vacuum) and gives time which is accurate
to 1 second every million years. Your Radio Controlled Watch even accounts automatically for daylight saving time.
Automatic Time Setting
Your Analog talking radio controlled watch recalls your selected Atomic Clock signal automatically at 3:00AM every night. After reception of signal it will show the
official local time on the watch. Everything is done automatically. However, your watch can also be manually set.
Button Functions:
S1
● Press S1 (2 o'clock button) to talk Hour and Minute

Press S1 twice to talk Calendar. (There is preset a calendar talking like the RC talking clock).
 Press S1 3 times to talk reception status. If the reception was successful, the watch will say "Country name" follow by "Time Updated". If the reception was
failed, the watch will say "Country name" follow by "Time Not Updated"
S2
 Push S2 (4 o'clock button) once to check alarm time setting and if the alarm is set to ON or OFF (the watch says the alarm time follow by "Alarm is ON" or
"Alarm is OFF")
Crown
Use to reset all hands to 12:00:00 position. When the crown is pulled out, the watch stops immediately.
Your watch should be positioned in the following shape and put near by a window during signal reception or you would not be able to get the best reception result.
Metal Case with metal Band
-Never let the metal band touches the case-back as it will affect signal reception.
-Never put the watch by its side as it will not able to get signal on this position.
Correct positions for signal reception
For metal case with metal band watch, the watch-band should be away from the watch case as show below (insert the match box between the case back and the
metal band) or it will affect the reception.
Manual Signal reception:
You have to set the watch with the right country before you do the following manual signal reception.
Go to "Country Signal Selection" for details.
You have to put the watch on a table nearby a window when you need a manual signal reception. Please pay attention on the position of the watch. You must put
the watch on the table according to position show on the picture below or the watch will not be able to pick up signal.
While the watch is in the normal running mode,

Holding S1 (2 o'clock button) until the second hand stops.

The watch takes about 5 to 14 minutes to pick up radio signal. Wait until the watch has finished the signal receiving procedure.

After signal reception, the watch will show the time again after the fast running of the second-hand has stopped and resume normal running.

Push S1 (2 o'clock button) 3 time after the watch resume normal running to check the reception status.
-If the reception was successful, the watch says "Country name" follow by
"Time Updated"
-If the reception was failed, the watch says "Country name" follow by
"Time Not Updated"
Radio Controlled Analog Talking watch with manual time setting
(77.5Khz Single Band work for Germany and countries where the DCF signal is available)
Reception Method of Radio Controlled Watches
Instruction Manual
4