Weighing Function - Linnuo IN-PW-1002 Gebrauchsanleitung

2. After you have chosen the storage cell (e.g. storage cell P3), the symbol for
sex will blink. To choose the desired sex (male or female), touch the ▲- or ‚▼-
button and then save by touching the SET button.
3. After you have chosen your sex (e.g. male), the indicator for age will blink
on the display (default age 30). In order to enter your age, touch the ▲- or ‚▼-
button and then save by touching the SET button.
4. After you have entered your age, the indicator for height will blink on the
display (default 170 cm). In order to enter your height, touch the ▲- or ▼-
button and then save by touching the SET button.
After you have finished entering your data, "0.0 kg" will appear on the display.
The scales are now ready and you can undertake a body analysis. Without
further activity the scales deactivate automatically after a few seconds. Your
personal data has been saved.
If you touch the SET button again within 2 seconds after the first input, you
can immediately enter the data of other people, and for a new entry you will
repeat completely the steps mentioned above.

Weighing Function

• Place the scales on a hard, flat surface (avoid carpets). An uneven floor
contributes to inaccurate measurements.
• The scales have a step-on function. Simply step onto the scales, keep still
and do not hold onto anything.
• After the scales have stabilised, your weight will be flashed at you three
times in succession and then be shown to you steadily for approximately 10
seconds.
• After weighing, step off the scales. After a few seconds the scales will
deactivate automatically.
Body analysis
An analysis is only possible when you are barefoot. The personal data must
be entered beforehand.
1. Activate the scales by touching the SET button. On the display the personal
data of the last setting will appear first. If this is not your data, choose the
storage field under which you saved your personal data using the ▲- or ‚▼-
button. Your personal data will be shown. Confirm each of these by touching
the SET button, after which the scales will return to "0.0 kg".
2. Now stand carefully barefoot with your feet on the scales, and remain still.
3. First you will be shown your weight. After that, while the body analysis is
being carried out, the signal "o" will run on the display. Remain standing still.
After the measurement has been taken the measured values will be shown to
you on the display:
Your body weight in kg
1. Your proportion of body fat in % (FAT) ***
6