Dual CS 455-1 Bedienungsanleitung Seite 8

Mounting or exchanging a pick-up cartridge system
Change of cartridge system
– Remove the coloured signal leads carefully from the cartridge
pins with a pair of tweezers.
– Unscrew the cartridge.
– Screw the new cartridge onto the head shell but do not
tighten. Attach the leads to the pins while observing the
correct coding.
Instead of the factory-supplied pick-up cartridge any other
cartridge with standard half-inch mounting holes and a weight
between 3 and 10 grams can be installed.
– Remove the coloured signal leads carefully from the cartridge
pins with a pair of tweezers.
– Loosen the collar-lock 9 behind the head shell. Carefully pull
the coloured signal leads out of the head shell. (Fig. 5). Install
the head shell in reverse order. Pay attention to the correct
colour coding
R = Red, right channel
RG = Green, right channel ground
L = White, left channel
LG = Blue, left channel ground
Adjusting after change of pick-up cartridge system
For the precise adjustment of the so-called stylus overhang push
the supplied mounting gauge into the head shell with cartridge.
The adjustment is correct if the stylus is flush with the V-shaped
recess in the gauge as viewed from above. When viewed from
the side the stylus should be seen within the rectangular recess
of the gauge (Fig. 7). Adjust the cartridge in the head shell until
the correct positions are achieved. Lastly, tighten the mounting
screws, put the head shell with cartridge back on the tone arm
and tighten the collar-lock 9.
ATTENTION!
During these mounting and adjustment procedures you must be
very careful not to damage the delicate stylus and cantilever by
uncontrolled and brisk movements.