Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING INSTRUCTIONS
EN
IsoForceControl EVO2
Dynamometer 10-400 N, to measure the muscle strength
Intended Use
The Dynamometer is intended for the installation and the use of indoor areas and is needed to
measure muscle forces. The device is designed to measure isometric muscle power over an
adjustable time span between 3 to 20 sec. It can determine the average value as well as the
fatigue. Any other use than described above can damage the device. No part of the product
may be modified or rebuilt!
This product complies with the applicable National and European requirements.
Package Contents
Dynamometer IsoForceControl EVO2
Tension strap
Suction holder
USB cable
4 batteries AA, 1,5 V
Software CD & Operatings Instructions
Hard protective case
Safety Instructions
Read the complete operating manual carefully before using the product as it contains important
information about the correct installation and operation.
We do not assume any liability for material and personal damage caused by improper handling or
noncompliance of safety instructions. In such cases the warranty expires.
The unauthorized conversion and/or modification of the product are not allowed for safety
reasons.
Caution!
The Suction holder may only be installed on smooth and airtight surfaces.
This Dynamometer may be used only for isometric force measurements.
The maximum load of 400 N should not be exceeded.
Any kind of jolts, twisting (torsion) and oscillation (e.g. by oblique pull) should be avoided.
wrong
right
wrong
V 1.3
1
Werbung
Inhaltsverzeichnis
