veito FLOW Installation Und Betriebsanleitung Seite 30

EN
In many cases, the installation site must be inspected by a qualified
electrician to determine the correct cable section and length.
Make sure to check that there is no electricity in any of the terminals before
making any electrical connections. In case of any doubt, disconnect the
main electrical current from the fuse panel.
Peel off the isolated outside of the electrical cable in a length of
approximately 5 cm, and connection cables in a length of approximately
1 cm by using a suitable tool. In the meantime, the power cord should not
be damaged.
Insert the device's power cord into the cable entry. Carefully connect the
connecting cables to the electrical connection terminals according to wiring
diagram.
Tighten the screws of the connection terminals and make sure the cable is
completely isolated to remain below the attachment screws. Loose
connections can cause overheating of the cord.
The power cord must be secured in accordance with TSE standards in
terms of both its installation in the wall and its protection.
As with all electrical equipment because of weakenings that may arise due
to use and aging, device and its installation should be checked by a
qualified electrician with an interval of at least two years.
Do not turn on the electricity until the front cover of the device is closed.
Before closing the front cover of the appliance, pressure safety switch must
be opened.
Place the front cover on the back cover. Make sure that bearings on the
edge of covers are correctly placed in the slots on the back cover.
Turn the level control switch on if necessary.
-30-