Programming The Reaction Time For The Arrow Buttons; Programming Decoders - LGB Universalhandy 55015 Bedienungsanleitung

ID 7. (The MTS central unit calls up commands
more often from ID 1 and ID 2 than from higher ID
numbers).
If the ID numbers for all MTS items are left in
their original state, then the ID number does not
have to be set.
• Press Buttons
and
F
number. Then, the ID number currently set,
example: , will be shown. The programming
P 1
function must first be released by pressing the
button in order to avoid accidentally chan-
ging the ID number.
will then appear in the display. Now enter
P -
the desired ID number. The Universal Hand
Controller will then change automatically to the
mode previously selected.
If the Universal Hand Controller does not carry
out set commands for turnout decoders, then
the ID number has been changed accidentally.
Set the ID number back to "1".
6. Programming the Reaction Time
for the Arrow Buttons
If you hold down the arrow buttons in the locomo-
tive operation mode, the locomotive will continue
to accelerate or brake. You can program how fast
the individual speed levels are controlled in the
process, i.e. how fast the locomotive accelerates
or brakes.
• Press Buttons and
F
reaction time for the arrow buttons.
The display will show the programmed value.
• The programming function must first be
released by pressing the
avoid accidentally changing the reaction time.
will then show in the display.
P -
• Enter the desired reaction time, between 1 (fast
= 0.3 seconds pause between the speed levels)
and 7 (slow = 1.2 seconds pause between the
speed levels).
• The Universal Hand Controller will then change
automatically to the previous mode.

7. Programming Decoders

7.1 Installing the Programming Module
You can program all MTS locomotive decoders
and MTS turnout decoders with the Universal
Hand Controller. To do this you must remove
125963_55015_Universalhandy_A5.indd 11
in order to set the ID
5
in order to program the
6
button in order to
the module with the black cable and replace it
with the programming module included with the
Universal Hand Controller.
• Press on the two grooved tabs at the top of the
Universal Hand Controller and carefully pull the
insert out.
• Insert the programming module.
• There are four colored wires on the program-
ming module:
- Connect the brown and the white wire
directly to the MTS turnout decoder or to a
programming track on which the locomotive
or the car with the decoder to be program-
med has been placed.
- Connect the yellow and the green wire to a
transformer (min. 18 volts / 2 amps).
• Now, plug the transformer into the house cur-
rent.
7.2 Carrying Out Programming
All of the decoders are programmed in the same
manner. In the instructions for each decoder,
you will find the CVs (Configuration Variables)
which you can use to program the settings for the
decoder. For example, the decoder address on all
11
25.04.2013 13:17:14