Dometic MWO24 Bedienungsanleitung Seite 16

Troubleshooting
Error code Fault
F.03 Internal voltage supply
default
F.04 Low-voltage protection
tripped
F.05 Overvoltage protection
tripped
F.06 Overheating of the
electronics
16
Explanation/remedy
➤ Press the
button for more than
3 seconds to turn off the microwave oven.
➤ Contact the manufacturer's branch in your
country (see the back of the instruction
manual for the addresses) or your specialist
dealer.
The display shows the
and the current voltage is displayed.
You hear 2 signal tones at an interval of one
second.
After 10 seconds, the microwave oven switches
off.
➤ Check the charge state of the vehicle
battery.
➤ If necessary, start the vehicle engine to
charge the vehicle battery.
The display shows the
and the current voltage is displayed.
You hear 2 signal tones at an interval of one
second.
After 10 seconds, the microwave oven switches
off.
There is a fault in the 24 V on-board supply.
➤ If necessary, turn off the vehicle engine.
➤ Turn the microwave oven on again.
➤ If the error code is still displayed, then
contact your vehicle dealer or a workshop.
➤ Press the
button for more than
3 seconds to turn off the microwave oven.
➤ Wait at least 30 minutes before you put the
microwave oven back into operation.
➤ If the error code continues to be displayed,
contact the manufacturer's branch in your
country (see the back of the instruction
manual for the addresses) or your specialist
dealer.
MWO24
symbol and ERROR
symbol and ERROR
EN