Setup; Mounting; Use - EuroLite LED MINI FE -4 Bedienungsanleitung

Mounting

This product is designed for overhead rigging to a wall or ceiling with the mounting bracket. It can also be
fastened to a truss using appropriate clamps. To align the unit, release the fixation screws at the mounting
bracket, adjust the desired inclination angle and retighten the fixation screws.
Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure that the
device is installed securely and cannot fall down. Make sure that the installation complies with the
standards and rules that apply in your country, in particular EN 60598-2-17.
• The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
• The device must be additionally secured with e.g. an appropriate safety bond. Fasten the safety bond in such a
way that, in the event of a fall, the maximum drop distance of the device will not exceed 20 cm. This secondary
safety attachment must be constructed in a way that no part of the installation can fall down if the main
attachment fails.
• You must only use safety bonds and quick links complying complying with DIN 56927, shackles complying with
DIN EN 1677-1 and BGV C1 carbines. The safety bonds, quick links, shackles and the carbines must be
sufficiently dimensioned and used correctly in accordance with the latest industrial safety regulations (e. g. BGV
C1, BGI 810-3).

Use

Setting up your new light effect only takes a minute. Simply connect it to the mains via the power adapter provided
and turn it on. You're ready to go: Select the desired show and speed and the light dances through the room. Use
the remote control to control the unit conveniently from a distance. When actuating a button, always hold the
remote control in the direction of the sensor at the control unit's front or rear. There must be visual connection
between the remote control and the sensor.
Notes
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the foil
from the battery support on the rear side of the remote control. Otherwise operation of the remote control is not
possible.
• If the range of the remote control decreases, replace the battery. For this purpose, on
the rear side of the remote control press the small bar with the groove to the right and at
the same time remove the battery support. For operation, one 3 V button cell type CR
2025 is required. When inserting, pay attention that the positive pole of the button cell
shows upwards in the support.
Mounting bracket

SETUP

Truss mounting clamp
WARNING!
13 • EN
Safety bond
Fixation screw