TREEPOD STAND Bedienungsanleitung Seite 5

3. Turn the topper over so it is standing
3
upright on the legs.
4. Tip the partially
4
assembled unit on two
of its supports and slide
the male end of a middle
section leg pole into
the female end of a top
leg section. Insert bolts
through the pre-drilled
holes from the outside.
Place a washer and lock
washer onto the bolt from
the inside. Then screw on
a nut cap. Tighten using
the wrench to secure.
Repeat with the other two
middle sections.
5. Tip the partially assembled unit
5
on two of its supports and slide
the male end of a base section
leg pole into the female end of
a middle leg section. Insert bolts
through the pre-drilled holes from
the outside. Place a washer and
lock washer onto the bolt from
the inside. Then screw on a nut
cap. Tighten using the wrench to
secure. Repeat with the other two
base sections.
6. Using at least two people, lift the Stand and place in the desired location to hang the TreePod.
TREEPOD STAND INSTRUCTION MANUAL - ENGLISH