TREEPOD STAND Bedienungsanleitung Seite 4

INSTRUCTIONS:
PARTS
1 Topper 3 Leg Poles - Top
1 Wrench
(2 female ends)
3 Leg Poles - Middle
1 Ring with Webbing 18 Hex Bolts
(poles with a male end and female end)
18 Cap Nuts
3 Leg Poles - Base
(poles with a male end and rubber-capped end)
18 Washers 18 Lock Washers
ASSEMBLY:
1. Lay out all of the parts identifying
1
the sections of each leg.
2. Lay the topper on the ground
2
with prongs up and insert the
female end of a top section leg.
Insert bolts in the pre-drilled
holes along top leg section from
the outside. Place a washer and
lock washer onto the bolt from
the inside. Then screw on a nut
cap. Tighten using the wrench to
secure. Repeat with the other two
top leg sections.
TREEPOD STAND INSTRUCTION MANUAL - ENGLISH