Inhaltsverzeichnis
Werbung
CAUTION!
Pressing a button on the teaching trans-
mitter during the learning routine may cause
the door to move if the receiver programmed
to trip the door is located in the near vicinity!
Note
The learning routine will be cancelled if you release the
button on the learning transmitter during the slow-flashing
phase.
Fig.
3
Activate/deactivate the lockout
Alternately press both control buttons quickly in any order.
The following LED signals indicate whether or not this process
was successful:
• Lockout activated – three quick signals
• Lockout deactivated – one long signal
Fig.
4
Fastening to a key
The HSD2 hand transmitter is fastened to a key as seen in
Fig.
4
.
12
09.2007 TR20A020-A RE
Werbung
Inhaltsverzeichnis
