Inhaltsverzeichnis
Werbung
When programming or making extensions to the remote
control make sure that persons or objects are not located
within the movement range of the door.
1. Place the transmitter that is to "teach" the code (teaching
transmitter)
(learning transmitter)
2. Press and hold the designated button on the teaching
transmitter. The LED will then light up and remain lit.
Note
The signal lockout must be deactivated – see Fig.
3. Press and hold the designated button on the learning trans-
mitter immediately afterwards – the LED on the learning
transmitter will flash slowly and begin to flash quicker when
the learning routine was successful.
4. Release the buttons on both transmitters.
Do a function test! If the transmitter does not function
correctly, repeat steps 1-4.
09.2007 TR20A020-A RE
O
A and the transmitter that is to learn the code
O
B directly next to one another.
3
.
11
Werbung
Inhaltsverzeichnis
