Rotheigner AirFlow 200 Bedienungsanleitung Seite 83

and/or repair operations.
· Misuse of the device or
any unauthorized modifi-
cations are not allowed.
· The device must not be
used to activate water
heaters, room heaters, etc.
· Do not touch the device
with wet or humid parts
of the body (e.g. hands or
feet).
· The electrical system to
which the device should
be connected must com-
ply with the acting lo-
cal electrical norms and
standards.
· The device can be con-
nected to the supply mains
only if the voltage and the
frequency of the supply
mains correspond to those
written in the rating label.
· The fixed electrical wiring
must be equipped with an
automatic circuit breaker
with the gap between the
breaker contacts on all
poles not less than 3 mm
(overvoltage category III
conditions).
· Take steps to prevent in-
gress of smoke, carbon
monoxide and other com-
bustion products
the room through open
chimney flues or other
fire-protection
Sufficient fresh air sup-
ply must be provided for
proper combustion and
exhaust of gases through
the chimney of fuel burn-
ing equipment to prevent
back drafting. Consult the
local norms with regards
to this.
· It is forbidden for the de-
vice to discharge air into
hot air ducts used for the
evacuation of fumes com-
ing from the combustion
into
devices.
GB
83