Genua XSi Hardware Kurzanleitung Seite 13

A label with three barcodes and hardware information is attached to the
chassis. One barcode contains the MAC address, the second one contains
the genua machine ID and the last one contains the hardware serial
number.
The XSi hardware can be mounted vertically or horizontally on a DIN rail
(also known as a cap rail or top hat rail outside of Europe). The DIN rail
clamps shipped with the unmodi fied XSi hardware have already been
assembled. Mounting the device on DIN Rails:
1. When mounting the hardware on
the rail, the rail clamp side with
the spring must be on top.
2. Insert the clamp into the rail from
above.
3. Then press the lower part of the
XSi hardware to the rail until the
rail clamp catches in the rail.
13