Werbung
Verfügbare Sprachen
Verfügbare Sprachen
en
Maintenance and care of the
hand-held turbobrush
(see illustration on page 2)
,
Always disconnect the vacuum
cleaner from the electrical supply for
maintenance work and for cleaning.
Switch off at the wall socket and
withdraw the plug.
Removing threads and hairs
^ Cut any threads or hairs that have
become entangled in the roller with a
pair of scissors. There is a groove
along the roller to help you.
Then run the vacuum cleaner to
vacuum up the bits.
For more obstinate tangles or
blockages inside the hand-held
turbobrush, the cover can be opened.
Any large particles inside it can then be
easily removed.
^ Press the release button and remove
the cover.
^ Remove any soiling from the cavity
and from the roller brush.
^ Replace the cover.
12
Changing the threads lifters
Check the thread lifters on the suction
inlet from time to time and replace them
if the pile has worn down.
^ Using a knife or similar object lever
the thread lifters out of their holders.
See positions marked red at the
sides.
^ Fit new thread lifters.
Werbung
