Use And Application / Operating Instructions; Commissioning; Changing The Battery - Ecom Ex-Time 40 Bedienungsanleitung

7. Use and Application / Operating Instructions

Before use, please read these operating instructions very carefully
in order to familiarise yourself with the functions of the Ex-Time
40. For you own safety and information, please read the following
instructions.

7.1 Commissioning

Use an appropriate screwdriver to undo the two screws on the
battery compartment cover (on the opposite side from the quartz
mechanism). Remove the battery compartment cover and insert a
battery of the correct type (LR14) (refer to the table under section
6.1 – Table with type-approved batteries ) into the battery compart-
ment. Please refer to the diagram on the housing to make sure
that battery is inserted with the correct polarity. Refit the battery
compartment cover (the spring faces towards the battery), refit the
battery compartment cover screws and tighten securely. Then use
the white adjusting wheel on the housing of the clockwork mecha-
nism in order to set the correct time.

7.2 Changing the battery

To change the battery, use an appropriate screwdriver to undo the
two screws on the battery compartment cover. Remove the battery
compartment cover and dispose of the old battery.
Insert a new battery (only use type-approved batteries ' refer to the
table under section 6.1 – Table with type-approved batteries; check
for correct polarity ' check the diagram on the battery housing
). Refit the cover to the battery compartment (the spring faces
towards the battery) and secure it with the two screws. The clock
will now start to run again. Then use the white adjusting wheel on
the housing of the quartz mechanism in order to set the correct
time.
Please ensure that all used and defective batteries are properly
disposed of in an environmentally friendly manner.
15