Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Tool applications:
•
Spot Weld Drill:
Drill bit mounting dangers:
•
Correct drill bit mounting is necessary to prevent injury from broken or loosen drill bits.
•
Do not use chipped or cracked drill bits.
•
Tighten the drill bit in the chuck using the enclosed hex spanner.
•
Before drilling, test the drill bit by briefly running tool at full throttle. Be sure to use a
barrier (such as under a heavy working table) to stop any possible loosen drill bit.
•
A broken or loosen drill bit will cause serious hurts !
•
Never use a drill bit marked with a speed lower than this tool !
•
Do not wear jeweled or loose clothing and avoid long hair.
•
Choking can happen if neckwear is not kept away from tool and accessories !
•
Avoid direct contact with accessories during and after use. Safety gloves will reduce the
risk of cuts or burns.
•
Use only proper accessories retainers (refer to parts list).
•
Use drill bits with the correct shaft diameter, dimension and approvable speed according
to the technical data of this tool.
•
This unit has been developed as spot weld drill and must only used for this function. Any
misuse could occur serious health damage.
Dangers in use:
•
Do not lay down the device before all the rotary parts stopped
•
Do not keep the air tool running while carrying it.
•
Maintain a firm grip on the power tool and position your body and arm to allow you to
resist kickback forces. Always use auxiliary handle, if provided, for maximum control
over kickback or torque reaction during start-up. The operator can control torque
reactions or kickback forces, if proper precautions are taken
•
Never place your hand near the rotating accessory. Accessory may kickback over your
hand.
•
Switch off the unit immediately in case of blocking or twist. Disconnect the air supply and
do not switch on again until the problem is solved. Understand the reason why the tool
has been blocked and make sure that this situation will not occur once more by
counteract.
To drill spot welds on motor vehicles
Safety instructions for spot weld drill
18
Werbung
