Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Pneumatic tool and safety instructions
•
The goal of Bendel Werkzeuge is to offer tools that help your work safely and efficiently.
•
The most important safety device for this or any tool is YOURSELF.
•
Your care and good judgment are the best protection against injury. All possible hazards
cannot be considered here, but we have tried to highlight some of the most important
ones.
•
This tool may only used by qualified people.
•
This tool and its accessories must not be modified.
•
Do not lay down the device before all the rotary parts stopped.
•
Do not keep the air tool running while carrying it.
•
Maintain a firm grip on the power tool and position your body and arm to allow you to
resist kickback forces. Always use auxiliary handle, if provided, for maximum control
over kickback or torque reaction during start-up. The operator can control torque
reactions or kickback forces, if proper precautions are taken.
•
Never place your hand near the rotating accessory. Accessory may kickback over your
hand.
•
Switch off the unit immediately in case of blocking or twist. Disconnect the air supply and
do not switch on again until the problem is solved. Understand the reason why the tool
has been blocked and make sure that this situation will not occur once more by
counteract accordingly.
Air supply and connection hazards:
•
Air under pressure can cause several injury !
•
Always shut off air supply, drain hose of air pressure and disconnect tool from air supply,
when not in use, before changing accessories or maintenance.
•
Never put direct air at yourself or anyone else.
•
Whipping hoses can cause serious injury. Always check for damaged or loose hoses
and fittings.
•
Do not exceed maximum air pressure according on the name plate respectively 6.3 bar.
•
Do not use quick disconnect couplings directly at the tool. See instructions for correct
set-up !
For additional safety information consult:
•
Your employer, union and/or trade association.
•
Council of the European communities and/or local codes
•
,,Safety requirements for hand-held non-electric Power Tools", available from: European
committee for standardization, Rue de Stassart 36. 1050 BRÜSSEL, BELGIEN.
http://www.cen.eu/cenorm/homepage.htm
16
Werbung
