Inhaltsverzeichnis
Werbung
44
Trouble-shooting table aid
Problem
Possible causes
Hand switch / drive
system not functioning
plugged in
connected
hand switch
box
power failure the hand switch
changes to locked status)
system is defective
Drives only operates for
a short time when
buttons are pressed
Function LED on hand
switch not lit or lit conti-
nuously when button is
pressed
Individual drives operate
in one direction only
drives or control unit
The wrong function is
active when hand switch
incorrectly connected (mixed up)
buttons are pressed
Drives stop suddenly
after prolonged adjust-
(drive unit) is triggered on
ment times
Continuous or longer
lasting signal without
using hand switch
G
P
EBRAUCHSANWEISUNG
FLEGEBETT
Main power cable is not
Wall socket defective
Hand switch plug not properly
Functions are blocked on
Drives locked at the locking
Hand switch locked (after
Hand switch or drive unit
Too much weight on the bed
Bed is blocked by an obstacle
Defective drive
Drive is at end position
Locking function is activated
Load limit exceede
Defective hand switch, motor
Internal motor plugs
Thermo switch in transformer
Drive unit system is defective
GIGANT · I
NSTRUCTION
Solution
Insert main power cable
Check wall socket/fuse box
Check connector plugs
Unlock functions (see
page 22)
Unlock knob at locking box
Change locked status on the
hand switch with magnet key
Inform your operator about
necessary repairs
Reduce load
Remove obstacle
Inform your operator about
necessary repairs
Remove drive from end
position
Unlock locking box
Reduce load
Inform your operator about
necessary repairs
Inform your operator about
necessary repairs
Pay attention minimum pause
(see page 19)
Inform your operator about
necessary repairs
M
N
B
GIGANT
ANUAL FOR
URSING
ED
Werbung
Inhaltsverzeichnis
