Operating And Indicating Elements - IFM Electronic SmartLink DP AC1375 Montageanleitung

Operating and indicating elements

You are informed about the state of the master and the connected
system by means of four diagnostic LEDs on the SmartLink DP.
• LED PWR/COM lights:
• LED PWR/COM flashes: AS-i voltage present, but no slave was
• LED PROJ lights:
• LED PROJ flashes:
• LED CONF/PF lights:
• LED CONF/PF flashes:
• LED Profibus DP lights:
10
AS-i voltage present, at least one slave
was detected
detected correctly
Projection mode active, the configuration
monitoring is deactivated
Projection mode active, switching to the
protected mode not possible as a slave
with the address 0 is connected.
Projected and current configuration do
not match
Peripheral fault on at least one connected
slave
Bus error Profibus DP