Connect Led Strip; Connect Power Pack - Schluter Systems Schluter-LIPROTEC Gebrauchsanleitung

Output 4
Output 5

6.3 Connect LED strip

If you wish to connect one or several LED strips to the

Bluetooth receiver, read the
chapter 6.

6.4 Connect power pack

You can identify the 24V input of the Bluetooth
receiver by the following features (see also fig.
A):
– Flag labelled "24 V DC"
– A third, thinner, white cable – this is the antenna of
the Bluetooth receiver
In order to connect the Bluetooth receiver to the power pack,
proceed as follows:
Lay the connection cable of the 24V input of the

Bluetooth receiver to the 24V terminals of the power
pack.
Bluetooth receiver directions for use
–
–
LED strip directions for use
Connection
Red (-),
max. 2.0 A
Blue (-),
max. 2.0 A
EN
,
57