Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Working steps
1. Marking the recess: to do this, lay the device upside
down, flat on the worktop and mark the outline with a
sharp pencil. Observe the dimensions 588 mm x 331 mm
and the perpendicularity in the drawing opposite.
2. Marking opening in the table plate: similarly, the
opening in the table plate must also be marked by copy-
ing the already drawn outlines to an inner outline that is
scaled down by 5 mm.
3. Cutting out the opening: cut out the opening in the
table plate (see 2.) using a suitable tool. Cleanly carve
out the 4 mm recessed area opposite the table surface
for the device support with a suitable tool (e.g. a router)
since the corresponding edges remain visible edges. For
materials other than wood, please check with your shop-
fitter for the correct method.
4. Plugging in supply line: plug the supply line into the
device and feed the cable down through the opening in
the table plate. Ensure the plug is secured properly.
5. Placing the mounting frame: place the device onto
the incorporated table edge in the installation position
and check the evenness with the table plate surface to-
gether with the glass plate. Rework if necessary. Please
note: the device should be oriented depending on the
operating side desired. Consider carefully the ventilati-
on point as well.
6. Sealing the cut surface: after checking the accuracy
of fit, it is recommended to seal the cut surface against
the penetration of fluids.
7. Laying cable: expertly fix cable in the sideboard under
the table plate. Ensure that the cable is not accidentally
chafed by moving parts and subjected to tensile loads.
There should be no drawers under the installation de-
vice unless there is a stable partition wall above it.
8. Masking the surface: it is recommended to mask the
joint edges along the glass plate and the worktop sur-
face with suitable crepe tape sufficiently wide to enable
clean and quick operation.
9. Filling joints: grout the constant 2 mm wide circum-
ferential groove evenly with a suitable joint sealer (e.g.
Sikaflex®-221) according to its handling instructions.
Joint sealer is not included in the scope of delivery. Ple-
ase only use materials suitable for food areas! Pay par-
ticular attention to selecting suitable joint sealer (e.g.
natural stone silicone) for stone worktops to prevent dis-
colouration. Also ensure an absolutely clean groove to
prevent contamination in the joint sealer.
10. Applying joints neatly: Apply joint sealer with the
help of a sealant applicator.
11. Leaving joint sealer to dry: Handle joint sealer ac-
cording to manufacturer's instructions and leave to dry.
6
Werbung
