Remote Temperature Sensor - jokey AVANO Prelude 80 Gebrauchshinweise

6. RF Remote Temperature Sensor
Installation / Use of the RF remote outdoor temperature sensor
Please decide first on one of the two 2 installation options:
1.You can mount the device outside (provided it is sheltered from the rain)
without any additional sensor cable. Seal the connector socket with plastic plugs.
2.You can keep the device indoors, connect the sensor cable and lead the
sensor cable + temperature sensor outside. This is the recommended option.
Advantage: the outside temperature can be read at 2 points on the mirror
cabinet und on the remote sensor e.g. inside at the window.
Further proceedings:
Connect the mirror cabinet to the mains system. Insert the batteries into
the remote sensor. Do not screw the lid on again yet. Wait until reliable radio
contact (communication) has been established with the mirror cabinet:
Press the thermometer symbol in the mirror cabinet display for several seconds
until the top right side
starts to counts down. During the countdown, press the "Tx" (= transmitter button
on the rear of the RF remote sensor on the left-hand side over the batteries)
several times. This establishes radio contact with the mirror cabinet and
encodes the system (to prevent any undesirable interference from other radio
sources in the neighbourhood). Now screw on the battery lid.
This process must be repeated each time the batteries are changed or in
the event of malfunctioning.
Set up the remote sensor in a standing position or snap down the holder,
screw it onto the wall and click the temperature sensor into place again.
Ensure that the device is not exposed to large fluctuations in temperature
(e.g. do not put on a heater).
If the mirror cabinet is switched on again after it has been disconnected from the
mains system (e.g. by another switch), "88.8 °C" appears as outside temperature
for a moment (max. 2 min).
During this time the radio communcation is established again between
the outside temperature sensor and the mirror cabinet (the temperature sensor
does not transmit constantly statutory regulation).
No liability can be assumed for the consequences of temperature display
inaccuracies or misinterpretations. This also applies to the indoor temperature
sensor. Neither temperature sensor is an "official measuring instrument"
Note regarding the indoor thermometer: If you so wish, the temperature sensor
can also be mounted outside the mirror cabinet. When delivered, the sensor is
on the back of the mirror cabinet along with an extension lead approx. 3 m long
(white lead!). Decide on where to place it before hanging the mirror cabinet
on the wall.
of the display shows the time "10"(seconds), which then
17