i-tec SOLAR Benutzerhandbuch Seite 5

Voice dialling
1. First, activate the function of the voice dialling on your telephone and record the voice commands.
Details could be found in the manual of your telephone.
Note: For use of the voice dialling, this function must be supported also by your mobile telephone and
You must have in your telephone (NOT ON THE SIM CARD) saved the voice commands.
2. Briefly depress the pushbutton MFB (5).
3. From the loudspeaker, a short sound signal will be heard.
4. Pronounce the voice command. Handsfree shall repeat your voice command and implement it automatically.
5. For terminating the call, depress MFB (5)
Note:
- For terminating the dialling number, depress MFB (5) long
- Hiss and noises in your surrounding may affect the function of voice dialling. Record your voice commands in a quiet location.
Repeat of the last dialled number (Redial)
For redialling of the last called number (Redial) depress 2x the pushbutton MFB (5). From the loudspeaker, a short sound signal will be
heard.
RediRectiNG the cALL BetWeeN the teLePhONe ANd the hANdSfRee.
from handsfree to telephone
Depress simultaneously the pushbuttons VOL+ (2) and VOL- (7) for about 3 sec or, switch the Handsfree off. The call will be redirected
into the telephone.
from telephone to handsfree
Depress simultaneously the pushbuttons VOL+ (2) and VOL- (7) for about 3 sec or switch directly to phone. The call will be redirected from
the telephone into the Handsfree.
Reject A cALL (ONLy iN the PROfiLe hANdSfRee)
Depress the pushbutton MFB (5) for about 3 sec. to hear a short sound signal.
Volume control
Volume control is exercised by pushbuttons VOL+ (2) and VOL- (7) – this could be done after pairing as well as during the phone call.
Note: In case that high loudness is selected, there may be occasioned a decrease in quality of the phone call (echo, hisses from the
surroundings)
Mute mode
To convert the call into mute, depress the Mute pushbutton (1) once. LED lights red: Return to normal mode is implemented by repeated
depression of the pushbutton Mute (1) for 3 sec. and the LED shall commence to flash blue again.
hold the call mode
- 2x shortly press button MFB (5). Return to normal mode - 2x shortly press button MFB (5) again.
3 - 4